CANOGA PERKINS 9175 Command Reference - Manual (Page 180)

CanogaOS Command Reference
11-8
Command Mode
Interface mode
Default
The default state for the remote loopback is not supported. If a timeout is not configured,
the local DTE remains in remote loopback state until the remote DTE responds or the user
stops remote loopback administratively.
Examples
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ethernet oam remote-loopback supported
Switch(config-if)# ethernet oam remote-loopback 2
11.12 ethernet oam remote-loopback start
Use this command to start an Ethernet OAM remote-loopback mechanism.
Command Syntax
ethernet oam remote-loopback start
Command Mode
Privileged Exec mode
Default
The default state of the remote loopback function is disabled.
Usage
This command is used to start a remote loopback mechanism.
Examples
Switch# configure terminal
Switch# ethernet oam remote-loopback start interface eth-0-1
11.13 ethernet oam remote-loopback stop
Use this command to stop an Ethernet OAM remote-loopback process.
Command Syntax
ethernet oam remote-loopback stop
Command Mode
Privileged Exec mode
Default