CANOGA PERKINS 9175 Command Reference - Manual (Page 211)

CanogaOS Command Reference
15-2
no switchport
ip address 10.56.0.201/16
ip ospf authentication-key ijklmnop
!
router ospf 201
network 10.0.0.0 0.255.255.255 area 10.0.0.0
network 192.168.0.0/16 area 0
area 10.0.0.0 authentication
area 0 authentication
Related Commands
ip ospf authentication-key
15.2 area
Default
-cost
To specify a cost for the default summary route sent into a stub or not-so-stubby area (NSSA), use the
area Default -cost command in router configuration mode. To remove the assigned default route cost,
use the no form of this command.
Command Syntax
area area-id default-cost cost
no area area-id default-cost
area-id Identifier for the stub or NSSA. The identifier can be specified as either a decimal
value or as an IP address.
cost Cost for the default summary route used for a stub or NSSA. The acceptable value is
a 24-bit number.
Default
cost: 1
Command Mode
Router configuration
Usage
The command is used only on an Area Border Router (ABR) attached to a stub or NSSA.
There are two stub area router configuration commands: the stub and Default -cost options of the area
command. In all routers and access servers attached to the stub area, the area should be configured as
a stub area using the stub option of the area command. Use the Default -cost option only on an ABR
attached to the stub area. The Default -cost option provides the metric for the summary default route
generated by the ABR into the stub area.
Examples
The following example assigns a default cost of 20 to stub network 10.0.0.0:
interface eth-0-1