CANOGA PERKINS 9175 Command Reference - Manual (Page 255)

CanogaOS Command Reference
16-10
Switch(config) router bgp 100
Switch(config-router) bgp default ipv4-unicast
16.14 bgp default local-preference
Use this command to change the default local preference value.
Use the no parameter with this command to revert to the default setting.
Command Syntax
(no) bgp default local-preference PREF_VALUE
PREF_VALUE = <0-4294967295> Configure default local preference value.
The default local preference value is 100.
Command Mode
Router mode
Usage
Local preference indicates the preferred path when there are multiple paths to the same destination. The path
having a higher preference is preferred. Use bgp default local-preference command to define preference of a
particular path. The preference is sent to all routers and access servers in the local autonomous system.
Examples
Switch# configure terminal
Switch(config) router bgp 100
Switch(config-router) bgp default local-preference 2345555
Related Commands
set local-preference
16.15 bgp deterministic med
Use this command to have ZebOS software compare the Multi Exit Discriminator (MED) variable when
choosing among routes advertised by different peers in the same autonomous system.
Use the no parameter with this command to disallow this setting.
Command Syntax
(no) bgp deterministic-med
Default
Disabled
Command Mode