CANOGA PERKINS 9175 Command Reference - Manual (Page 151)

CanogaOS Command Reference
9-3
Command Mode
Interface configuration
Usage
This command is used to configure a switchport to dot1q-tunnel port.
Examples
This example shows how to configure a switchport to dot1q-tunnel port.
Switch (config-if)# switchport mode dot1q-tunnel
Related Commands
show interface switchport
9.5 switchport dot1q-tunnel type
Use this command to configure dot1q-tunnel type.
Command Syntax
switchport dot1q-tunnel type {basic | selective}
basic: Dot1q-tunnel basic type
selective: Dot1q-tunnel selective type
Command Mode
Interface configuration
Usage
This command is used to configure dot1q-tunnel type selective.
Examples
Switch(config-if)#switchport dot1q-tunnel type selective
Related Commands
show interface switchport
9.6 switchport dot1q-tunnel native vlan
Use this command to configure a switch-port’s default vlan.
Command Syntax
switchport dot1q-tunnel native vlan <1-4094>
no switchport dot1q-tunnel native vlan <1-4094>
native: Configure default vlan for dot1q tunnel port
1-4094: vlan id
Command Mode
Interface configuration