CANOGA PERKINS 9175 Command Reference - Manual (Page 147)

CanogaOS Command Reference
8-11
This example shows how to enable erps domain 11.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# erps 11 enable
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: transit
ERPS ring 1 edge node mode: edge
ERPS ring 1 node state: link up
ERPS ring 1 edge interface name: eth-0-9
ERPS ring 1 common interface name: eth-0-13
EPRS ring 1 SRPT is disabled
Related Commands
None
8.12 show erps
Use this command to show the configuration for specific erps domain.
Command Syntax
show erps ERPS_ID
ERPS_ID <1-255>: ERPS domain ID <1-255>
Command Mode
Exec and Privileged Exec
Usage
None
Examples
This example shows how to display the configuration for erps domain 11.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16