CANOGA PERKINS 9175 Command Reference - Manual (Page 274)

CanogaOS Command Reference
16-29
Switch# configure terminal
Switch(config)# router bgp 100
Switch(config-router)# mpls-resolution
16.44 neighbor activate
Use this command to enable the exchange of the specified AF routes with a neighboring router.
Use the no parameter with this command to disable exchange of information with a neighbor.
Command Syntax
(no) neighbor NEIGHBORID activate
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used
with a command, the command applies on all peers in the specified group.
Command Mode
Address Family mode and Router mode
Usage
After the TCP connection is opened with the neighbor, this command is used to enable or disable the
exchange of the specified AF information with a neighboring router.
To enable the exchange of multicast and VPNv4 address prefix types, neighbors are activated using the
neighbor activate command in address family mode.
Examples
Switch# configure terminal
Switch(config)# router bgp 10
Switch(config-router)# neighbor 1.2.3.4 activate
Related Commands
neighbor remote-as
16.45 neighbor advertisement-interval
Use this command to set the minimum interval between sending the BGP routing updates.
Use the no parameter with this command to set the interval time to default.
Command Syntax
(no) neighbor NEIGHBORID advertisement-interval TIME