Leica Geosystems Leica mojoRTK User Manual
Page 121
Advertising
Leica mojoRTK, Normal System Operation
121
Configuring NMEA Output, step-by-step
1. Switch on the mojoRTK console and from the Navigation screen press
to
enter the main menu.
2. Use the main dial to select Settings -> Extended Features -> NMEA settings.
3. Select Output Enabled to turn NMEA output on, and then press
.
4. Select Baud Rate to change the RS232 baud rate, and then press
. Use the
main dial to scroll through the list of baud rates. Press
to select a rate or
to cancel.
5. To change the output rate of a sentence select the desired sentence from the
menu, and then press
. Use the main dial to select either Off, 1 Hz, 5 Hz,
10 Hz or 20 Hz. Press
to select a rate or
to cancel.
Not all sentences support output rates greater than 1 Hz.
Advertising