Answering device & telephone, Problem, Cause & remedy – Panasonic KX-F195 User Manual
Page 96: The unit does not work when any button is pressed, Some voice-messages have not been fully recorded
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The unit does not operate properly.
•Turn the POWER switch off, then turn it on again.
Problems when receiving
international facsimiles.
•Shorten your OGM to 10 seconds or less.
•FAX RX SPEED may need to be set to 4800 bps.
See page 5-2.
Answering Device & Telephone
PROBLEM
CAUSE & REMEDY
The unit does not work when any
button is pressed.
•Turn the POWER switch off, then turn it on again.
The unit has been set to the
TAD/FAX mode, but no
voice-messages have been recorded.
•The tape is not installed properly or is broken
(cut, worn out or twisted). Install the tape or
replace it with a new one.
When the tape is played, the sound
level is low or nothing can be heard.
•Raise the sound level using the VOLUME
control.
•Clean the head of the cassette deck
compartment. See page 6-5.
I have played back all the recorded
messages and I want to record the
next call after the last message.
•Leave the unit as it is after hearing the messages.
I cannot retrieve recorded messages
from a remote phone.
•Make sure that you use your REMOTE TAD ID
number correctly,
•When you press your REMOTE TAD ID number,
press the buttons firmly.
Some voice-messages have not been
fully recorded.
•Set the calling party control (CPC) to
“B”. See
page 5-3.
When a caller hangs up after leaving
a message, the tape does not stop.
•VOX TIME should be set to 4 seconds. See page
5-7.
The unit does not ring.
•Set the RINGER volume selector to the HIGH or
LOW position.
6-3