Doepfer A-100(~ 40 MB) - Manual (Page 109)

doepfer System A - 100 Multitype Morphing Filter A-107
5
Programming Unit Controls:
1 Display: 3 digit LED display
2 Step: button, calls up display mode "Step"
3 Filter: button, calls up display mode "Filter"
4 Chain: button, calls up display mode "Chain"
5 Prog: button, calls up display mode "Prog"
6 Value: rotary encoder to set the value for
Step, Filter and Chain
7 Step: two CV inputs with/without attenuator,
and manual control for Step setting
8 Step Clock: digital signal input for clock/gate-
triggered advance to next step
9 Step Reset: digital signal input to set the step to a
position within the chain defined by the
momentary step CV
0 Morph: two CV inputs with/without attenuator,
and manual control for morphing time
Filter Unit Controls:
! Audio In: audio input of the filter
" Freq.: two CV inputs with/without attenuator,
and manual control for filter frequency
§ Res.: two CV inputs with/without attenuator,
and manual control for filter reso-
nance/emphasis
$ Amp.: two CV inputs with/without attenuator,
and manual control for filter amplifica-
tion
% Audio Out: audio output of the filter