Doepfer A-100(~ 40 MB) - Manual (Page 435)

doepfer System A - 100 LFO A-145
3
3. Controls and indicators
1 LED ... 2 LED
LEDs 1 and 2 show the frequency of the voltage
output at sockets " to $.
H If the LFO frequency goes above about 15
Hz, our persistence of vision means that the
LEDs look permanently on.
3 Frequ.
This control adjusts the frequency of the LFO, within
the parameters of the frequency range set by switch
4
.
4 Frequ. Range
Use switch 4 to select a suitable frequency range from
the three available:
• L (low):up to several minutes per cycle
• M (medium): normal LFO range
• H (high): audio range
4. In / Outputs
!
This is the output for the inverted sawtooth.
(Amplitude:
± 2.5 V).
"
This is the output for the ordinary sawtooth, whose
frequency is displayed by LED 1.
(Amplitude:
± 2.5 V).
§
This is the output for the sine wave, whose frequency
is displayed by LED 2. (Amplitude:
± 2.5 V.)
$
This is the output for the triangle wave, whose fre-
quency is displayed by LED 2. (Amplitude:
± 2.5 V.)
%
This is the output for the square wave
(Amplitude:
± 2.5 V.)