Doepfer A-100(~ 40 MB) - Manual (Page 531)

doepfer System A - 100 Clock Divider A-160
1
1. Introduction
Module A-160 (Clock Divider) is a frequency divider
for clock signals, designed to be a source of lower
frequencies, particularly for rhythm uses.
The Trigger input will take clock signals from, eg., an
LFO, MIDI sync, or the gate from a MIDI-CV interface.
At the outputs, you have access to the sub-divided
clock signals, from half the clock frequency down to
1/64.
The A-160 also has a reset input. Whenever a reset
signal is sensed, all outputs are set to zero, until the
reset voltage disappears.
The Clock Divider can be used in combination with the
A-161 Clock Sequencer to produce stepped sequen-
ces with a length of from one to eight events.
/ 2
/ 4
/ 8
/ 16
/ 32
/ 64
Trig.
In
Res.
In
A-160
CLOCK
DIVIDER