A-112, System a - 100, Doepfer – Doepfer A-100(~ 40 MB) User Manual

Page 202

Advertising
background image

A-112

Sampler

System A - 100

doepfer

12

H

During Data transmission via MIDI OUT the
MIDI input and gate are not scanned. There-
fore a new dump cannot be triggered by
mistake.

Gate = high:
As soon as the gate goes high (e.g. by pressing button
4

) the sample memory is transferred as a SysEx dump

via MIDI OUT and LED 3 turns on (same function as
sample dump request via MIDI in).

H

To trigger a sample dump manually a short
high gate level is sufficient. It is not neces-
sary to keep the gate level high.

• Wave dump mode

This mode is very similar to the normal dump mode
(see above). The difference from the normal dump
mode
is that the data of a single wavetable (page) of
256 bytes is transferred instead of the complete
sampling memory of a bank.

The number of the wavetable is determined by the
position of the tune control 2 and the voltage applied
to CV input ".

• Delay mode

This mode generates a simple delay. The incoming
audio signal is delayed and passed to the audio out-
put.

H

The memory bank S2 is overwritten in this
mode!

Principle: The incoming audio signal is sampled and
written into a memory position in bank S2. Before this
the old value at this position is transferred to the audio
output. The number of the memory position is in-
creased by 1 and the process is repeated. When
reaching the last memory position the process starts at
memory position 1. The last memory position depends
upon the length (Len, see below).

5

5

5

5

6

6

6

6

7

7

7

7

Audio / Wave-CV In

Tune / CV

S1,

S2

Dmp Wav

wave page num-

ber

5

5

5

5

6

6

6

6

7

7

7

7

Audio / Wave-CV In

Tune / CV

Eff

Del

Norm

audio signal

sampling fre-

quency

Advertising