Doepfer A-100(~ 40 MB) - Manual (Page 663)

doepfer System A - 100 MIDI-CV/SYNC Interface A-190
9
CV CHAR.
This parameter sets the voltage control characteri-
stics of the pitch CV output from the A-190, so that it’s
possible to drive both common types of analog synth -
older Korgs, Yamahas, etc., which have a linear re-
sponse (Hz / V), and Rolands, ARPs, Moogs, etc.,
which have a logarithmic response (1V / octave).
H For use just with the A-100, the V / octave
response is all that is needed. The Hz / V
option is provided purely for connecting to
external synths which use that standard.
M M M M
V / Octave : PROG CHANGE 3
Hz / V : PROG CHANGE 4
RETRIGGER
This parameter enables you to choose between single
and multiple triggering of the ADSR. With RETRIG-
GER on, every time a key is pressed, another gate
signal is sent, even if (ie in legato playing) another
key is still held down at the time.
M M M M OFF : PROG CHANGE 5
ON : PROG CHANGE 6
H This parameter can also be changed in per-
formance mode. If, even with RETRIGGER
ON, the gate isn’t reliably re-triggered, set a
higher value for the gate retrigger time in
CONFIG menu 5.