KEYENCE LK-H2 - Manual (Page 20)

2-8
2
2 Preparations before Operating
Installing the USB Driver
This procedure is not required for Windows 7, Vista, XP, or 2000 because the installer
installs the USB driver when installing LK-Navigator 2.
This procedure explains how to manually install the USB driver in the event the LK-
Navigator 2 installer was canceled before installing the driver. When the USB driver is
installed on the PC, the PC will automatically recognize the controller.
• This procedure explains the installation process for Windows XP.
• Before starting the installation, close any other applications currently running.
• When installing on Windows 2000 Professional, Windows XP Professional, Windows Vista, or
Windows 7, you must logon as a user with administrator privileges.
• The USB connector on the controller is Type B. Use a USB cable with a Type B connector on one end.
• The controller complies with the USB 2.0 High Speed standard. The USB has downward
compatibility for communicating with PCs that support USB 1.1.
1
Start the controller and PC.
2
Connect the controller and PC with the USB cable.
The "Welcome to the Found New Hardware Wizard" appears.
3
Insert "LK-H2" in the CD-ROM drive, and click "Next".
The "Please wait while the wizard installs the software..." dialog appears, indicating
installation has started.
If the installation finishes normally, the "Completing the Found New Hardware
Wizard" dialog appears.
• If the following dialog appears during the installation process, click "Continue".
• The "Welcome to the Found New Hardware Wizard" screen may appear for some
versions of Windows. In this case, select "No, not this time", and click "Next".
4
Click "Finish".
This completes the installation of the USB driver.
NOTE
Reference