KEYENCE TM-3000 Series - Manual (Page 22)

3-4
Operat
ion
s wit
h t
h
e Set
ting
File
s
- Setup software TM-H1 TM-Navigator User’s Manual -
Sending and Receiving Settings
Sending and Receiving Settings
This section describes how to transmit all settings
between TM-Navigator and the controller.
Settings that are changed in TM-Navigator are updated
to the controller immediately after being sent. Settings
from the controller are reflected to TM-Navigator
immediately after being received.
This function transmits the following data to the controller.
• All of the settings for program No. 0 to 15 (Head
settings, Master registration, Position correction,
Measurement settings, OUT settings, Common
settings)
• Controller environment settings
Sending All Settings
1
Connect TM-Navigator and the
controller, and check that
communication is normal.
"Connecting via USB" (page 1-7)
"Connecting via Ethernet" (page 1-9)
2
Click the [Send settings to controller]
icon on the tool bar.
Select [Send the settings to the controller] from the
[Comm] menu.
The [Communicating] dialog appears.
The dialog closes when sending the settings is
complete.
Receiving All Settings
1
Connect TM-Navigator and the controller,
and check that communication is normal.
"Connecting via USB" (page 1-7)
"Connecting via Ethernet" (page 1-9)
2
Click the [Receive settings from
controller] icon of the tool bar.
Select [Receive the settings from the controller] from
the [Comm] menu.
The [Communicating] dialog appears.
The dialog closes when receiving the settings is
complete.
Alternative
Alternative