KEYENCE TM-3000 Series - Manual (Page 39)

4-17
Displa
ying
the
Measurem
ent Data
- Setup software TM-H1 TM-Navigator User’s Manual -
Data Storage
Starting data storage
1
Connect TM-Navigator and the
controller, check that communication
can be established, and then measure
the target.
"Connecting via USB" (page 1-7)
"Connecting via Ethernet" (page 1-9)
2
Set the storage settings to "Data
storage" in the common settings for
the controller.
"TM-3000 Series User's Manual"
3
Click the [Data storage] icon on the tool
bar.
The [Data storage] window appears.
4
Click the [Start storage] button.
The controller starts storing the measurement
values.
When the amount of stored data matches the value
set for [No of data points] in the [Data storage]
dialog box, the storage stops automatically.
Reference
• The storage interval depends on the trigger settings
and data output timing settings. Data can be stored in
succession or at a specified timing. To stop the data
storage halfway, click the [Stop storage] button.
When you click the [Start storage] button again after the
storage is stopped once, the storage is resumed from
the point where the storage was stopped.
• If communication is not possible between TM-Navigator
and the controller, or if a head is not connected, the
following dialog appears shortly after clicking the [Start
storage] button or the [Read storage data] button.
Check the connection between each head and
between TM-Navigator and the controller. Check that
the controller is set to [Data storage].
Loading the storage data
Displays the data stored in the controller on TM-
Navigator.
1
Connect TM-Navigator and the
controller, check that communication
can be established, and then measure
the target.
"Connecting via USB" (page 1-7)
"Connecting via Ethernet" (page 1-9)
2
Start or stop data storage according to
"Starting data storage" (page 4-17).
3
Click the [Read storage data] button.
The storage data is displayed on TM-Navigator.