AERCO C-More Controls Manual June 2010 - Manual (Page 20)

C-More Controller for Benchmark, Innovation & KC
USER MANUAL
Page 20 of 162 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, New York 10913 04/22/14
GF-112 Phone: 800-526-0288 OMM-0032_0E
2.3 OPERATING MENU
The Operating Menu displays the unit status and a number of key operating parameters for the
unit as listed in Table 2-1. This menu is “Read-Only” and does not allow personnel to change or
adjust any of the displayed items. Since this menu is “Read-Only”, it can be viewed at any time
without entering a password. Press the
▲ arrow key to display the menu item in the order listed
(Top-Down). Pressing the
▼ arrow key will display the menu items in reverse order (Bottom-
Up).
NOTE
The Outdoor Temp display item shown with an asterisk in Table
2-1 will not be displayed unless the Outdoor Sensor function has
been enabled in the Configuration Menu (Table 2-3).
Table 2-1: Operating Menu
Menu Item Display
Available Choices or Limits
Default
Minimum Maximum
Status Message
Active Setpoint 40°F 240°F
Air Temp -70°F 245°F
Outdoor Temp* -70°F 130°F
Valve Position In 0%
Max Valve
Position
Flame Strength 0% 100%
Run Cycles 0 999,999,999
Run Hours 0 999,999,999
Fault Log 0 9 0
2.4 SETUP MENU
The Setup Menu (Table 2-2) permits the operator to set the unit password which is required to
change any of the menu options. To prevent unauthorized use, a previously entered password
entry will time-out after 1 hour.
Therefore, the password must be reentered when required. In addition to permitting password
entries, the Setup Menu is also used to enter date and time, language to be used for display
messages, units of temperature measurements and entries required for external communication
and control of the unit via the RS232 port. A view-only software version display is also provided
to indicate the current Control Box software version,