AERCO C-More Controls Manual June 2010 - Manual (Page 7)

C-More Controller for Benchmark, Innovation & KC
USER MANUAL
04/22/14 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, New York 10913 Page 7 of 162
OMM-0032_0E Phone: 800-526-0288 GF-112
SECTION 1 - GENERAL INFORMATION
1.1 INTRODUCTION
The information in this Section provides a guide to the operation of Benchmark, Innovation and
KC Series units using the C-More Control Panel. In addition, it provides information describing
the numerous types of external sensors and control devices that can be interfaced to the unit
using terminals provided in the Input/Output (I/O) Box utilized by the Control Panel. Information
regarding the set-up of all water heater and boiler Operating Modes, as well as Water Heater
Management (WHM) Systems and Boiler Sequencing Technology (BST) Systems of units is
also included.
IMPORTANT
Unless otherwise specified, the descriptions, procedures and
menu items contain in this manual apply to all C-More software
versions.
1.2 SAFETY PRECAUTIONS AND WARNINGS
It is imperative that the initial startup of KC, Benchmark and Innovation units be performed by
factory trained personnel. Operation prior to initial startup by factory trained personnel will void
the equipment warranty. In addition, the following WARNINGS and CAUTIONS must be
observed at all times.
CAUTION:
All initial installation procedures must be satisfied before
attempting to start the unit.
WARNING:
ELECTRICAL VOLTAGES IN KC SERIES AND INNOVATION
UNITS INCLUDE 120 AND 24 VOLTS AC. VOLTAGES IN
BENCHMARK SERIES UNITS MAY ALSO INCLUDE 460 AND
220 VOLTS AC. THEREFORE, THESE UNITS MUST BE
SERVICED ONLY BY FACTORY CERTIFIED SERVICE
TECHNICIANS.
WARNING:
DO NOT ATTEMPT TO DRY FIRE THE UNIT. STARTING THE
UNIT WITHOUT A FULL WATER LEVEL CAN SERIOUSLY
DAMAGE THE UNIT AND MAY RESULT IN PERSONNEL
INJURY OR PROPERTY DAMAGE. THIS SITUATION WILL
VOID ANY WARRANTY.