AERCO C-More Controls Manual June 2010 - Manual (Page 33)

C-More Controller for Benchmark, Innovation & KC
USER MANUAL
04/22/14 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, New York 10913 Page 33 of 162
OMM-0032_0E Phone: 800-526-0288 GF-112
SECTION 3 - CONTROL PANEL MENU DESCRIPTIONS
3.1 MENU ITEM DESCRIPTIONS
Descriptions of the menu items and options contained in each of the seven (7) major menu
categories are listed and described in Table 3-1.
Table 3-1: Menu Item Descriptions
MENU LEVEL & OPTION DESCRIPTION
Operating Menu
Active Setpoint
This is the setpoint temperature to which the control
is operating when operating in the Constant Setpoint,
Remote Setpoint or Outdoor Reset (boiler only)
Mode. When in the Constant Setpoint Mode, this
value is equal to the Internal Setpoint setting in the
Configuration Menu. When in the Remote Setpoint
Mode, this value is the setpoint equivalent to the
remote analog signal supplied to the unit. When
operating a boiler in the Outdoor Reset Mode, this is
the value derived from the chart in Appendix B.
Air Temp
Air Temp displays the temperature of the air input to
the Air/Fuel Valve. This reading is one of the
components used to calculate blower motor speed
during the Combustion Calibration process.
Outdoor Temp
Displayed only if outdoor sensor is installed and
enabled.
Valve Position In
Desired input Valve Position. This would normally be
the same as the Valve Position shown on the bar-
graph (Valve Position out) when the boiler is
operating.
Flame Strength Displays flame strength from 0 to 100%.
Run Cycles
Displays the total number of run cycles from 0 to
999,999,999.
Run Hours
Displays total run time of unit in hours from 0 to
999,999,999.
Fault Log
Displays information on the last 20 faults (numbered
0 through 19).