About dialing patterns, Creating dialing patterns – AltiGen MAXCS 7.0 Update 1 ACM Administration User Manual
Page 185
Configuring Out Call Routing
MaxCS 7.5 Administration Manual 169
About Dialing Patterns
If your system is using a route access code, most likely you have one of the following situations:
•
Your area may have multiple 10-digit dialing area codes.
•
Your area may have both 10-digit and 1+10 digit dialing in a same area code.
•
Your system needs to borrow another system's trunk to make an outbound call over an IP or tie trunk.
•
You would like to block a dialing pattern in addition to system restriction setting.
Dialing patterns are exceptions. If you can, minimize the number of dialing pattern entries. Most companies
don’t need to create dialing patterns.
Creating Dialing Patterns
1.
Click the Dialing Pattern tab on the Out Call Routing Configuration window.
Figure 106.
Out Call Routing Configuration, Dialing Pattern tab
2.
Click the Add button.
3.
Type in the prefix and pattern length, and click OK.
4.
Assign routes to this prefix by selecting routes from the lists in the Route Priority section of the Dialing
Pattern
tab.
5.
If this is a restricted number or pattern, skip step 4 and check the Disallow this dialing pattern check box.