AltiGen MAXCS 7.0 Update 1 ACM Administration - Manual (Page 363)

Using SNMP
MaxCS 7.5 Administration Manual 347
• Softswitch up (specific trap). When AltiServ.exe starts to respond to the keep alive packets sent by the
SNMP Agent. AltiServ should respond to the keep-alive packets after its initialization is completed.
• Softswitch down (specific trap). When AltiServ.exe stops responding to the keep-alive packets sent by the
SNMP Agent.
• Gateway/Media Server connection up (specific trap). When a gateway or HMCP Media Server connection
state transitioning from down to up is detected.
• Gateway/Media Server connection down (specific trap). When a gateway or HMCP Media Server
connection state transitioning from up to down is detected.
• Enterprise Manager Master up (specific trap). When MAXCS is in Enterprise Manager slave role and En-
terprise Manager master state transitioning from down to up is detected.
• Enterprise Manager Master down (specific trap). When MAXCS is in Enterprise Manager slave role and
Enterprise Manager master state transitioning from up to down is detected.
• Enterprise Manager Slave up (specific trap). When MAXCS is in Enterprise Manager master role and
detects Enterprise Manager slave state transitioning from down to up.
• Enterprise Manager Slave down (specific trap). When MAXCS is in Enterprise Manager master role and
detects Enterprise Manager slave state transitioning from up to down.
• IP Phone service up (specific trap). When detecting IP Phone service transitioning from down to up.
• IP Phone service down (specific trap). When detecting IP Phone service transitioning from up to down.
• VM server connection up (specific trap). When detecting VM server connection transitioning from down to
up.
• VM server connection down (specific trap). When detecting VM server connection transitioning from up to
down.
• CT Proxy Service up (specific trap). When CTProxy Service connection transitioning from down to up is
detected.
• CT Proxy Service down (specific trap). When detecting CTProxy Service connection transitioning from up
to down.
• Excessive memory usage on Softswitch (specific trap). When MAXCS detects the lowest virtual memory
usage exceeds a specified percentage of physical memory configuration within a 10-minute duration. The
next trap will be sent after the condition is cleared then occurs again. The minimum duration between any
two consecutive traps is 30 minutes.
• Excessive CPU utilization on Softswitch (specific trap). When MAXCS detects its average CPU utilization
exceeds a specified percentage in any 10-minute duration. The next trap will be sent after the condition is
cleared then occurs again. The minimum duration between any two consecutive traps is 30 minutes.
• Excessive hard disk usage on Softswitch (specific trap). When hard disk usage of MAXCS transitioning
from below threshold to on or above threshold is detected. The minimum duration between any two
consecutive traps is 30 minutes.
Additional Traps Included with Release 7.5
MaxCS 7.5 includes many additional traps to enhance event monitoring:
• SIP Trunk Group Status traps (Trunk Group Up, Trunk Group Down, Trunk Group Busy)
• SIP Abnormality traps (Out of HMCP codec resources, insufficient SIP extension channels, malicious IP
address added)
• Security traps (Toll fraud - outbound call from voicemail exceeding call duration threshold or call quality
threshold, 911 call, extension lockout)