AltiGen MAXCS 7.0 Update 1 ACM Administration User Manual

Page 415

Advertising
background image

MaxCS 7.5 Administration Manual 399

Figure 233.

Signaling Layer

6.

In the E1 Channel Configuration dialog box, configure the following fields:

•

Set Calling Party Category to

– the Calling Party Category indicates the type of calling party, (for

example, operator, pay phone, priority, ordinary subscriber). Select 1, 2 or 3 (for ordinary subscribers,
refer to Table

on page 400). If the subscribed line is intended for other purposes, contact your CO for

the proper value.

•

Add extra digits before caller ID

– consult your CO to find out if any extra digits are needed.

•

Incoming sequences

– select check box and configure the sequence according to Table

on page

400.

•

In-call signaling

– configure the in-call signaling value according to Table

on page 400.

The circled fields in Figure

233 represent values that depend on your country and its corresponding trunk

property.

Note:

Consult your CO to find out if caller ID digits are provided in the lines.

Advertising
This manual is related to the following products: