AltiGen MAXCS 7.0 Update 1 ACM Administration - Manual (Page 312)

Chapter 24: Location-Based E911 (for Roaming Users)
296 MaxCS 7.5 Administration Manual
Figure 170. Enable password protection for E911 entry
3. Once you check that checkbox, the Password field above it becomes active. Enter a password. Your
entry will be the password that the user must enter in order to change the Location ID assigned to the
phone. Click OK.
Note: You can use the Apply To feature to apply this requirement and the password to multiple phones.
Assigning E911 Locations on AltiGen IP Phones
Administrators can either push the correct E911 Location ID to an AltiGen IP phone, or they can have users
enter the correct ID manually on the IP phone itself.
To push an E911 Location ID assignment to an AltiGen IP phone, follow these steps.
1.
Select PBX > Location Based E911 Configuration.
2. Click View E911 Assignments.
The table lists devices that have, at some point, registered with MaxCS.
3. Click a column to sort the table. You can also filter the data by choosing All, Active, or Inactive from the
Status Filter
pull-down menu.
Figure 171. The E911 Assignment table
The following table describes the fields in this panel.
Parameter Description
E911 LID (Location ID)
The Location ID assigned to this IP phone.
Note: A phone with a Location ID of "0 (Disabled)" either does not
have the correct firmware or does not have any E911 Location
ID assigned to it.
Number The extension number of this IP phone.