Top cover, Uek uhbh, Opening the top cover – Brother CM-2000 User Manual
Page 18: Closing the top cover
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up Your Typewriter
Top Cover
Opening the top cover
In order to insert a new cassette daisywheel, cassette ribbon or spool of correction tape,
first place the top cover ofthe typewriter to the upright position. Do this by placing both
hands on either end of the cover and lifting it upwards until it stands by itself.
1. The keyboard locks up when the cover is raised, and typing is not possible until it is closed
again,
2.
Opening the top cover has no effect on margin settings, tab settings or the correction
memory, all of which are retained without change.
3. While the cover is open, the message;
^C
u
UEK UHbh
will appear in the display.
Closing the top cover
After inserting the cassette daisy wheel, cassette ribbon or spool of correction tape, close
the top cover by replacing itto its original position. Ensure that it is firmly in place afterclosing.
Note:
If the top cover is closed with the unit switched
ON,
the carrier will automatically travel
to the left edge, then return to its previous position.