Inserting the new cassette daisy wheel, Removing the old cassette ribbon, Inserting the new cassette ribbon.... i – Brother CM-2000 User Manual
Page 20: Cassette ribbon
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up Your Typewriter
Inserting the new cassette daisy wheel
Grasping the 'ear' of the new cassette daisy wheel, slip it into the cassette guide slot and
slide it in as far as it will go.
Now press the locking lever back toward the platen until it clicks into place. Do not force
the lever. If you have any difficulty, recheck the cassette daisy wheel to ensure that it is
properly set and try again.
Notes:
1. Be sure that the ‘ear’ ofthe cassette daisywheel is to the right during insertion. Putting
it in backwards can damage both the cassette daisy wheel and the motor mechanism.
2.
If the cassette daisy wheel is not properly locked into position, characters will not be
properly typed.
3. There is a wide selection of Brother cassette daisy wheels available.
Cassette Ribbon
The wide range of Brother cassette ribbons available have two unique features in common:
they are clean and troublefree. Clean means that the ink goes where it is supposed to go,
on the paper, and not on your- hands!
Removing the old cassette ribbon
First, use the
[SPACEBAR]
or
[BKSP]
key to move the carrierto the center ofthe platen. To
remove the cassette ribbon, hold the cassette with both hands and raise the front end (that
near to the platen). Then, when the ribbon is clear, simply lift the cassette up and out
WEUS