Normal tabs, Normal tabs -7, Setting and using tabs – Brother CM-2000 User Manual
Page 61
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting the Line Format
Notes!
1. There must be at least 5 lines between the start position and the end position.
2.
The end position cannot be more than 16.5 inches or 4 1 9 . 1 mm from the top of the
page.
3.
The start and end positions are measured absolutely from the top edge of the page
and are completely independent of each other. Changing start position does not affect,
end position, and vice versa.
4.
When the carrier reaches the end of the page the following message will appear
^P
h
0E
end
-
press
correct
to
continue
.
If you wish to type an extra line, press the [CORRECT] key and continue typing.
If you wish to cancel the current page end setting, press [CODE] + [E SET] when the page
end is reached.
Setting And Using Tabs
Tabs allow you to move the typing position quickly and automatically to a preset position.
As their name suggests, they are useful for typing tables, and are also used for indenting
paragraphs.
Normal tabs
Normal tabs are left-aligned, i.e. the first letter of the text is aligned to the tab stop.
To set a normal tab:
1. Move the carrier to the position at which a tab is required.
2.
Hold down [CODE] and press the TAB SET key - [T SET].
3.
To use the tab stop, press theTAB k e y - [TAB], and the carrier will move to the tab
position automatically.