Setting start position (top margin), Setting end position (page length) – Brother CM-2000 User Manual
Page 60
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting the Line Format
The minimum width between left and right margins depends on the typing pitch, as shown
in the following table.
Pitch
Min Margin Width
Expand mode
10
20 characters
10 characters
12
24 characters
1
2
characters
15
30 characters
15 characters
Setting Start Position (Top Margin)
Automatic paper insertion normally sets the paper so that typing will start approximately
one inch (25.4 mm) from the top of the page. However, you can change this position using
the
START SET
function, so that auto-insertion will set the paper to a start position
anywhere between one and six inches (25.4 and 152.4 mm) from the top of the page.
To set the start position:
1. Insert a sheet of paper and press the
[P INS]
key to auto-insert the page.
The display will show the message; .¿iPRESS RTN«
However, if you wish to setthe start position you should not press
[RETURN]
at this stage.
2.
Use
[INDEX]
and
[R INDEX]
to adjust the position of the page to where you wish
to begin typing,
3.
Hold down
[CODE]
and press the
START SET
key -
[S SET]
to save that setting as
the start line.
Setting End Position (Page Length)
The appearance of multi-page documents is enhanced ifthetext ends at the same position
on each page. Your typewriter allows you to set the page length using the
END SET
function, so that you cannot type below the end position.
To setthe end position;
1. First insert the paper as above, using the
[P INS]
key. Do not press
[RETURN],
2.
Use
[INDEX]
and
[R INDEX]
to adjust the paper to the desired end position.
3.
Hold down
[CODE]
and press the
END SET
key -
[E SET]
to set the end position.