Brother CM-2000 - Manual (Page 24)

Setting Up Your Typewriter
Switching The Machine On And Off
Before switching on for the first time, check that there is no floppy disk in the disk drive
on the right-hand side of the machine, as this can complicate matters, if there is a disk in
the drive, press the rectangular button to eject it.
Use of the disk drive will be discussed later.
The power switch is located on the left hand side of the machine near the back. To switch
on, press the side of the switch marked 1 - ON so that the red bar on the switch is visible.
To switch off, press the side of the switch marked O - OFF.
When you first switch on yourtypewriter, the machine will initialize itself The carrier will
move to the extreme left position, then to the left margin, and the daisywheel will rotate,
then stop. During this time the display will show the message;
■v
■ ¿iniUKK ING
»= = a
After this the MAIN MENU screen appears.
\
'CriiH 1N MEHU.i^
S" 1 U.< jii = -I' ■ r ! Y
r'E
■H" = r
I
L.C. rift
<_____________________________________________________
■!r'-iSbc.lih.r'‘íT
This gives you the four operating options of your typewriter
You can select these options in one of two ways;
1. Usethe leftand right cursor keys — and to move the rectangularcursorsymbol
(1) to the option you wish to choose. Then press the [RETURN] key to confirm the
selection.
2. Use the shortcut of pressing the number key corresponding to the option you wish
to select. There is no need to press the [RETURN] key after pressing the number key,
the machine will go straight into the option you selected.
The
4
— and —^ keys can be used in almost all operations of the machine, for selecting
options and moving left and right across the display.