EVCO EVFTFT618N7U - Manual (Page 22)

EVCO S.p.A. EVFTFT618 | Installer manual ver. 2.2 | Code 144FTFT618E224
Page 22 of 62
6.1.4 Execution of an automatic cycle
Below find the illustration of the complete navigation system during the execution of an automatic cycle.
Once the automatic cycle is started, the following screen is displayed:
Press the START/STOP key to start the cycle. Press the START/STOP key for 3 seconds to interrupt the cycle.
The BAKING DELAY key allows to enable/disable
phase 5 of the cycle during execution
Main outputs status bar
In this screen it is possible to display the active alarms and
non-active alarms
In this screen it is possible to modify the set-points. Scroll the set-points
to be modified using the UP and DOWN keys and proceed with the
modification using the + and - keys. Once the modification has been
completed, press BACK to return to the menu
In this screen it is possible to display the time at which each phase ends
Item present only during the phases in which the
possibility of activation is envisioned
Once manual defrosting is pressed, the same will
start. The defrost symbol will appear in the cycle in
progress window.
By pressing the MENU key, reach the OPTIONS
screen
The internal values can be displayed on this screen