EVCO EVFTFT618N7U - Manual (Page 23)

EVCO S.p.A. EVFTFT618 | Installer manual ver. 2.2 | Code 144FTFT618E224
Page 23 of 62
6.1.5 The PROGRAMS menu
Below the complete navigation system of the PROGRAMS menu is illustrated.
This menu allows to select the program to be performed and/or modified. Once selected, press the SET key. In this way
the choice is confirmed and passes to the AUTOMATIC menu.
To reach the PROGRAMS menu from the pre-selection page, press the key at the side of the PROGRAMS icon:
If the program selected is not present, pressing the SET key will have no effect.
6.1.5.1 Modify Date and Time of Automatic Cycle End
The program end day can be moved up to 20 days after. The MINUS key only appears of the
day is modified, otherwise it is not visible as the date that is proposed is the first possible with the settings present.
Selection of the PROGRAMS menu allows to select a
retarder-proofer cycle from the 10 programs available
Use the UP and DOWN keys to scroll the programs available. Once the desired program has
been highlighted, press the SET key to confirm. The program selected will be re-proposed
will all settings in the first automatic cycle selection screen, i.e. with the selection of end
cycle time and date.
From this point, the cycle start-up and setup
management will be the same as those of
automatic cycle setting.