EVCO EVFTFT618N7U - Manual (Page 38)

EVCO S.p.A. EVFTFT618 | Installer manual ver. 2.2 | Code 144FTFT618E224
Page 38 of 62
12 Management of the Host USB port on the board
The EVFTFT618 model mounts a USB port on the board able to perform the following functions:
- Allows the download of the data relative to the cycles performed onto USB (historic)
- Allows to download the programs saved in the controller onto USB pen
- Allows to download the parameters saved in the controller onto USB pen
- Allows to upload the programs saved in the USB pen into the controller
- Allows to upload the parameters saved in the USB pen into the controller
On connection of a pen to the USB port on the machine, with board in stand-by, a window will appear that will allow to
access the menu described in the following flow-chart.
The connection of a USB pen in the USB
input cause the USB menu to appear,
from where it will be possible to select
and display the operation to be
performed
By selecting the HISTORICAL
DOWNLOAD menu By selecting one of these options the
execution screen will be shown
Press SET to pass from one field to
another and press START to begin the
download
The following screen will appear once
the download/upload once finished
In the case of download the following screen is obtained In the case of upload the following screen is obtained
The following screen will appear once
the download/upload once finished
Remove the USB pen Machine reset will be requested
On removal of the USB pen all
windows relative to USB
management will disappear
automatically
Just for the HISTORICAL DOWNLOAD operation
which can have very long duration, it is possible
to press ESC during the download and go back
to the pre-selection page to start new
cycles/procedures. A red USB icon will appear on
the display for the time the download is in
progress, while at the end of the download, the
USB icon will turn green to indicate that the pen
can be removed