EVCO EC6708 - Manual (Page 31)

Every Control S.r.l.
Via Mezzaterra 6, 32036 Sedico Belluno ITALY • Phone 0039-0437-852468 (a.r.) • Fax 0039-0437-83648 • [email protected] • www.everycontrol.it
31
OPERATOR MENU
Operator Menu configuration parameters
condensing probe is a PTC probe the unit of measure depends
from the parameter / t (the parameter / t belongs to the User
Menu; see the chapter User Menu on the page 32)
• the symbol (5) indicates that during the status ON the param-
eter is available both to the first and to the second level.
Pb r suction probe reading
It permits to display the pressure read by the suction probe.
Pb F condensing probe reading
It permits to display the quantity read by the condensing probe.
LABEL MIN. MAX. U.M. ANALOG OUTPUT READING
outF 0 100 % analog output reading (5)
Notes
• the symbol (5) indicates that during the status ON the param-
eter is available both to the first and to the second level.
outF analog output reading
It permits to display the analog output signal percentage.
For further informations about the parameter outF meaning see the
paragraph Analog output on the page 13.
LABEL MIN. MAX. U.M. CONDENSER FANS REGULATOR
F 1 F 6 F 7 (4) condenser fans activation setpoint (5)
Notes
• the parameters F 6 and F 7 belong to the User Menu; see the
chapter User Menu on the page 32
• the symbol (4) indicates that the unit of measure depends from
the parameter /bE (the parameter /bE belongs to the User
Menu; see the chapter User Menu on the page 32): if the
condensing probe is a 2 wires 4-20 mA pressure transducer
the unit of measure depends from the parameters /5P, /b6
and /b7 (the parameters /5P, /b6 and /b7 belong to the User
Menu; see the chapter User Menu on the page 32), if the
condensing probe is a PTC probe the unit of measure depends
from the parameter / t (the parameter / t belongs to the User
Menu; see the chapter User Menu on the page 32)
• the symbol (5) indicates that during the status ON the param-
eter is available both to the first and to the second level.
F 1 condenser fans activation setpoint
It has significance exclusively if the parameter /bE has value 1 or 2 and
if the parameter F A has value 0, it establishes the condensing quantity
value to which the instrument activates the condenser fans and it is
referred to the condensing probe.
The parameter /bE and F A belong to the User Menu; see the chapter
User Menu on the page 32.
For further informations about the parameter F 1 meaning see the
paragraph Condensing quantity regulation on the page 12.