EVCO EC6708 - Manual (Page 25)

Every Control S.r.l.
Via Mezzaterra 6, 32036 Sedico Belluno ITALY • Phone 0039-0437-852468 (a.r.) • Fax 0039-0437-83648 • [email protected] • www.everycontrol.it
25
e) after the display push and release the set key (to the release of
the set key the instrument displays the label Hr 7 again.
To gain access to the second level:
f) from the passage b keep pushed at the same time for four
seconds at least the up and the down keys (passed four sec-
onds the instrument displays the label ConF)
g) push and release the set key (to the release of the set key the
instrument displays the actual label value, for instance 0 and
the set LED flashes to indicate that a configuration parameter
modification procedure is running; passed four seconds with-
out operated with the keys the instrument automatically turns
out from a configuration parameter modification procedure)
h) push and release over and over the up or the down key within
four seconds as long as the instrument displays 113 (keeping
pushed the up or the down key the value gets increased or
decreased more quickly)
i) after the modification push and release the set key (to the
release of the set key the instrument displays Hr 1, the label of
CONFIGURATOR MENU
Configuration parameters setting
CONFIGURATION PARAMETERS SETTING
Configurator Menu configuration parameters are arranged on two
levels, to protect the most tricky settings against undesirable violations
and they are arranged in families that can be recognized through the
initial letter of the label.
To gain access to the first level:
a) verify if the instrument is in the status STAND-BY (repeat the
passages a and b of the chapter Before the use on the page 8)
b) keep pushed for two seconds at least the menu key (passed
two seconds the instrument displays the label Hr 1, the menu
LED turning on and the compressors/choking valves and con-
denser fans associated to the outputs K1 ... 8 LED turning on to
indicate the actual user-relay output configuration).
To select a parameter of the first level:
c) push and release over and over the up or the down key as
long as the instrument displays the label of the desired param-
eter, for instance Hr 7.
To display the parameter value:
d) push and release the set key (to the release of the set key the
instrument displays the actual value, for instance 26, the set
LED and the hours LED turning on to indicate respectively that
the value can not be modified and that the unit of measure of
the displayed quantity is the hour; passed four seconds without
operated with the keys the instrument automatically turns out
from a configuration parameter display procedure)