Communication connection – FingerTec AC100 Plus User Manual
Page 31
31
1
8
TOP
FRONT
1
8
Comm Opt
u
4Ethernet Yes
RS232
No
RS485
No
IP Addr
192. 168. 1.201
ESC OK
Note
COMMUNICATION CONNECTION
FingerTec® AC100 model can be connected to computer by four ways:
TCP/IP Connection
1. Setup the IP address by network configuration
The machine default IP address is 192.168.1.201; this is a legal and
available IP address in many LAN environment. If the host IP address
is 192.168.1.X and it is in the same network region, then this IP can
be used directly. If not, please make sure that you have changed the
IP address accordingly.
2. Setup of Ethernet.
Access Menu select “Options” > “Comm. Opt” > “Ethernet”, select
“Yes” to enable Ethernet function.
3. Turn the power off.
4. Plug the network plug to the Ethernet interface.
5. Turn the power on.
Ethernet 10/100Base-T Crossover Cable
This cable can be used to cascade hubs, or for connecting two Ether-
net stations back-to-back without a hub. It works with both 10Base-T and
100Base-TX.
Joint 1 Pin
Joint 2 Pin
TX+
1
•
• 3 RX+
TX-
2
•
• 6 RX-
RX+
3
•
• 1 TX+
RX-
6
•
• 2 TX-
When RS232/RS485/Ethernet is
enabled, only the Ethernet function
will be enabled while the RS232/
RS485 will be disabled.