FingerTec m-Kadex Manual - Manual (Page 14)

14 CONTENTS
4 • MANAGING USER
Enrolling Administrator Card
Administrator card is the first card to be enrolled into the terminal. Administrator card
cannot be used to report attendance or gain access. System administrator must main-
tain 2 cards, an administrator card to operate terminal, and a normal card for attend-
ance and access.
The administrator card is the key card to operate the terminal. To start or end an op-
eration such as enrolment of new card enrollment, deletion of card, and restoration of
terminal back to default factory settings, administrator card is required.
Registration of Administrator Card
Power up terminal > Green LED blinks continuously > Wave the card at the induction
area > Terminal beeps once > Green LED blinks > Terminal is ready
Remark: If the Green LED blinks continuously when you turn on the power, it means that the termi-
nal has already been enrolled with an Administrator card
Enrolling User Cards
Green LED blinks > Wave Administrator card twice at the induction area > Green LED
blinks > Wave the new user card at the induction area > Terminal beeps once and the
Green LED blinks > Repeat the steps to enroll next new user card > Wave the adminis-
trator card to induction area to end process > Green LED blinks
Remark: If the terminal beeps twice and red LED blinks after reading your card, the card has already
been registered to the terminal. You can’t re-enroll with this card. Please use another card.
Verifying Card for Attendance or Access
Green LED blinks > Wave your card at the induction area > Terminal beeps once >
Green LED blinks > If the card is verified successfully, the LED blinks in green
Remark: If the terminal beeps twice and the LED blinks in red after having read your card, your
card has not been registered into the terminal. Register your card first before trying to verify it at the
terminal.
Deleting User Card
LED blinks in green > Wave Administrator card 3 times at the induction area > LED
blinks in red > Wave the user card at the induction area > Terminal beeps once > LED
blinks green once > LED blinks in red > Repeat to wave next user card to delete >
Wave the administrator card to induction area to end process > LED blinks in green
Remark: If the terminal beeps twice and LED blinks in red after read your card, your card is not reg-
istered yet to the terminal. You can use this card to register with the terminal.