FingerTec m-Kadex Manual - Manual (Page 7)

7
1 8
TOP
FRONT
1 8
AL-
AL+
NC
COM
NO
BUT
GND
SEN
BELL+
BELL-
ACCESS CONNECTION PORT
Release
button
Door
sensor
Doorbell
+
-
2
3
A
C
EM lock
(NC)
Emergency
break glass
(NC)
Key switch
(NC)
J7 AL- AL+ NC COM NO BUT GND SES BELL+
BELL-
J2 RJ45-1 RJ45-2 RJ45-3 RJ45-6 J12 WDO WD1 GND RXD TXD GND 485A 485B
GND +12V V3.6 - 09032 J1
DC12V
Power Supply
GND
+12V
POWER SUPPLY PORT
Back of Terminal
AL-
AL+
NC
COM
NO
BUT
GND
SEN
BELL+
BELL-
ACCESS CONNECTION PORT
Release
button
Door
sensor
Doorbell
+
-
1
3
B
D
EM lock
(NO)
Emergency
break glass
(NO)
Key switch
(NO)
GND
+12V
POWER SUPPLY PORT
DC12V
Power Supply
NOTE
Please refer to AdapTec AC Installer Manual if
you are using AdapTec AC.
JOINT 1 PIN JOINT 2 PIN
TX+ 1
• •
3 RX+
TX- 2
• •
6 RX-
RX+ 3
• •
1 TX+
RX- 6
• •
2 TX-
J7 AL- AL+ NC COM NO BUT GND SES BELL+
BELL-
J2 RJ45-1 RJ45-2 RJ45-3 RJ45-6 J12 WDO WD1 GND RXD TXD GND 485A 485B
GND +12V
V3.6 - 09032 J1
Back of Terminal
For NC (normally close) door lock system
For NO (normally open)door lock system
CONTENTS
Descriptions of
Available
Connections
USB PORT
Linking with USB flash disk for re-
mote data transfer.
TCP/IP PORT
Connect with CAT 5 cable for LAN
connection, one end to this port
and another end to the compu-
ter’s TCP/IP Port.
TCP/IP for Single Connection:
Linking the terminal to a single com-
puter using TCP/IP requires Ethernet
10/100Base-T Crossover Cable. The
cable can be used to cascade hubs or
to connect Ethernet stations back-to-
back without a hub. It works with both
10Base-T and 100Base-TX.
TCP/IP for Network Connection:
Linking the terminals to multiple com-
puters using TCP/IP requires Ethernet
10/100Base-T Straight Thru Cable or
“whips”. The cable works with both
10Base-T and 100Base-TX, connecting a
network interface card to a hub or net-
work outlet.