FingerTec m-Kadex Manual - Manual (Page 5)

5 CONTENTS
Security Features
Security features help protecting the information from m-Kadex from being accessed
by unauthorized individual(s).
ADMINISTRATOR CARD
Registration of an administrator card to the system is important to control access into
m-Kadex. After registration of the administration card is done, nobody can do enroll-
ment, deletion or reset on m-Kadex without the administration card.
TAMPER SWITCH
m-Kadex comes with a tamper switch located at the rear of the terminal. During in-
stallation, the tamper switch is compressed against a wall. Any attempt to dismantle
m-Kadex will trigger alarm
Restarting and Resetting m-Kadex
If something isn’t working right, try to restart or reset m-Kadex.
RESTARTING m-Kadex
Use a thin probe to push the reset button hidden at the bottom of the terminal. The
terminal will restart by itself and all the memory is retained during this operation.
RESETTING TO DEFAULT FACTORY SETTINGS BY
ADMINISTRATOR CARD
Green LED blinks > Wave Administrator card 5 times at the induction area > The termi-
nal beeps 3 times > Red LED blinks > Wave Administrator card 1 time at the induction
area to confirm > Green LED blinks > The terminal beeps continuously for 7 seconds >
Green LED blinks
Remarks: All contents of the terminal will be deleted including the contents in administrator card. The
IP address of the terminal returns to default 192.168.1.201 after this process. The Terminal ID returns to
1 after this process.
RESETTING TO DEFAULT FACTORY SETTINGS WITHOUT
ADMINISTRATOR CARD
Green LED blinks > Detach terminal from a wall > Release security button > Wait for 35
seconds > Push and release the security button 3 times > Terminal would emit a long
beep and it will start the terminal
Remarks: All contents of the terminal will be deleted including the contents in administrator card.
The IP address of terminal returns to default 192.168.1.201 after this process. The Terminal ID returns
to 1 after this process.