FingerTec m-Kadex Manual - Manual (Page 8)

8
CONNECTOR PIN CABLE COLOR CONNECTOR
TX+ 1 • White/Orange • 1 TX+
TX- 2 • Orange • 2 TX-
RX+ 3 • White/Green • 3 RX+
4 • Blue • 4
5 • White/Blue • 5
RX- 6 • Green • 6 RX-
7 • White/Brown • 7
8 • Brown • 8
NOTE
Link all cables to the correct connection point(s) be-
fore attempting to connect the terminals to software.
CONTENTS
POWER SUPPLY PORT
Insert the Power Adapter point to this port for power.
RS232/RS485/WIEGAND CONNECTION PORT
RS232: Connection to a computer using RS232 cable.
RS485 Single Connection: Connection to a single computer using RS485 wire.
RS485 Network Connection: Connection to multiple computers using Daisy Chain connection.
Wiegand Output: Connecting with third party connector or terminal(s).
ACCESS CONTROL PORT
Linking the terminal to door lock system.
BELL PORT
Linking the terminal to doorbell.
Ingress Online Activation
Ingress is a genuine software by FingerTec. Every FingerTec access control model
comes bundled with a unique license key. To start using the terminal with Ingress, you
must connect the terminal to Ingress and perform online activation. Ingress reads the
serial number of your terminal and sends it for verification at the FingerTec server via
Internet.
In case you do not have an Internet connection, you would need to do offline activa-
tion. Please send the serial number and models of your terminals to your local resellers
or
[email protected] to request for a product key and activation key.
Installation and Setup of Ingress
Install Ingress in a PC that fulifills Ingress’ minimum requirements. Refer to http://
www.fingertec.com/customer/download/postsales/SUM-Ingress-E.pdf for the In-
gress user guide online. Setup Wizard will require you to do online activation before
connection establish between Ingress and terminals.