1 terminal activation via usb or usb/client, Workfl ow in summary – FingerTec TCMS V2 (Abridged Vesion) User Manual

Page 8

Advertising
background image

9

NOTE

3.1 TERMINAL ACTIVATION VIA USB OR USB/CLIENT

Make sure that you have a USB flash disk complete with information of

the terminal that you want to connect to TCMS V2. Change the

Con-

nection Type

to

USB

(or

USB/Client

if you are activating a TA300 termi-

nal). PLEASE NOTE that if you have more than 1 terminal connecting
via USB, you will need to change the device ID number. Please refer
to Chapter 2 of the TCMS V2 User Guide for instructions.

Choose the terminal model. The terminal of which its Product Key is

being used to install TCMS V2 will appear on the first line in the

Fin-

gerTec Terminal

window. Proceed by clicking on the relevant cell be-

low the Model header and choosing the model of terminal. Please go
to

product.fingertec.com

to find out more about FingerTec products.

There is a checker labeled

Disabled

on the far right of the FingerTec

Terminal window. Uncheck the

Disabled

button for the system to start

connecting to the terminal. The software may take a moment to do
so.

The system will prompt you to insert the Serial Number of your terminal.

Insert the correct serial number, which can be found on the same
hologram sticker pasted at the back of the FingerTec Going Green
DVD cover, and then press

Enter

. Once the

Apply

button is enabled,

click it to proceed.

You will now be prompted to insert the Activation Key of the terminal.

Insert the information, and then click

OK Save Close

. This establishes

the connection between the TCMS V2 software and the terminal via
USB and you can start downloading data from the terminal to TCMS
V2.

It is crucial that you save the information to avoid connection loss be-

tween TCMS V2 and the terminal. Once the terminal is activated in
TCMS V2, all icons on the software will be activated, and you are now
ready to configure and use TCMS V2.

Workfl ow in Summary

Click

Devices

icon

Setup FingerTec terminals

Choose the terminal

model

Uncheck

Disabled

button

Insert Serial Number

Enter Ap-

ply

Insert Activation Key

OK Save Close

Advertising