Futaba 4PK 2.4GHz - Manual (Page 103)

Communication port
(interior left side)
Cover
ESC receiver connector
Connecting ESC receiver
connector to the transmitter
Communication port
MC401CR
MC601C
MC850C
104
Fu
n
c
tio
n
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* W h e n t h e d ire c t c all but to n
is set, the setup screen is also
called by the following method:
-When the T4PK battery voltage drops,
the display switches to low battery display.
Therefore, use this function when there is
ample battery capacity remaining.
-Also connect the battery at the ESC side.
ESC Link Function "MCLNK"
This is a special function which lets you set the contents of the Link software which per-
forms Futaba speed controller (ESC), MC850C, MC601C, MC401CR, etc. variable frequen-
cy and other data changes by PC at the T4PK transmitter. However, the following MC401CR
settings cannot be used with the T4PK MC link function.
Reverse Mode Shift Level
Reverse (back) operation is enabled when once returned from brake operation to neutral.
Necessary brake operation amount setting for switching to this reverse operation.
Robot Mode
Setting which cancels the brake function with robot models, etc. and makes it forward and
reverse (back) continuous operation.
Reverse Cancel
Setting which cancels the reverse (back) function for forward and brake operation only.
This function is used by connecting ESC directly to the transmitter. The T4PK power switch
is used at the display side. Use the various optional servo extension cords according to the
distance between the transmitter and ESC.
The last data read from ESC to T4PK or the last data written from T4PK to ESC is saved to
the T4PK. Since the data for each model memory can be saved, the data of up to 40 models
can be saved.
ESC Link Function "MCLNK"