Futaba 4PK 2.4GHz - Manual (Page 67)

Setup items
PRST
: Preset position
MODE : Function selection
Setup item selection
- Select by (JOG) button up or
down operation.
68
Fu
n
c
tio
n
(Preparation)
- Use the function select switch to select the switch.
- Select the setting item "MODE" by (JOG) button up or down
operation. Press the (+) or (-) button and select "SW".
1
(Preset position setup)
Select the setting item "PRST" by (JOG) button up or down
operation, and use the (+) and (-) buttons to set the preset
position of the throttlle servo.
"B100" ~ "B1" :Brake side
"0" :neutral
"F1" ~ "F100" :Forward side
2
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
Engine Cut function adjustment
The throttle servo operating position (preset position) set by this setting is unrelated to
the setting of other functions. Maximum to minimum servo travel can be set. However,
the reverse function setting is enabled.
Servo Throw
When "CUT OFF", which prohibits trigger brake side operation, was set in the boat
mode (p.78), "TH-BRK" (brake side) of the EPA functions (p.49) cannot be adjusted.
The preset position set here becomes the linkage standard. Connect the linkage so that
the carburetor is fully closed and the engine is cut off in the preset adjustment range and
set the full throttle position by EPA function "TH-FWD". Adjust the idling position by
throttle trim.
When "TRG-BRK" was set to "CUT OFF" by boat mode function
Start Function, Engine Cut "START"
ｎ Caution
ｊ Always operate carefully before using this function.
While push switch SW1, SW2, or SW3 with preset function set is in the ON
state, the servo (motor controller) is locked in the preset position and does
not operate even if the throttle trigger is operated. If the servo was operated
at the wrong setting, you may lose control of the car (boat).
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Preset position (PRST)
B100 ~ B1, 0, F1 ~ F100
Initial value: 0
Setup item selection
- Select by (JOG) button up or
down operation.