Futaba 4PK 2.4GHz - Manual (Page 81)

Warning display
82
Fu
n
c
tio
n
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* W h e n t h e d ire c t c all but to n
is set, the setup screen is also
called by the following method:
This function is a function select switch function. The idle-up function ON/OFF switch
must be set. (Page 86)
It is used to improve engine starting performance by raising the idling speed when the
engine of a gasoline car (boat) is started.
This function is also effective when you want to prevent braking when the power was
turned off during running due to the effect of gear ratio setting and the motor used with
a motor car. However, when using the MC850C, MC601C, MC401CR, etc., check the
ESC neutral position and set the idling function switch to ON after the set enters the op-
eration mode, the same as the neutral brake function (page 80).
The throttle neutral position is offset to the forward side or brake side. There is no link-
age locking, etc. because there is no change near the maximum operation angle even
when the neutral position is offset by this function.
Operation
Idle-Up "IDLUP"
Idle-Up on/off state.
(Preparation)
- Use the function select switch function to select the switch. (page 86)
1
(Idle-Up rate)
Use the (+) and (-) buttons to set the Idle-Up rate.
2
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
Idle-Up function adjustment
The LED blinks while the Idle-Up
function is on.
Idle-Up "IDLUP" (Throttle system)
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Idle-Up rate (RATE)
D50% ~ D1%, 0%, U1% ~ U50%
Initial value: 0%
"D": Brake side
"U": Forward side
If the power switch is turned on
while the idle-up switch is on, an
audible alarm will be heard. Im-
mediately set the Idle-Up switch
to OFF.
While this function is ON, the LED blinks. (When LED
is active)
also appears on the initial screen and menu
screen.
Operation Display