Futaba 4PK 2.4GHz - Manual (Page 112)

Mode selection
"TRANSFER" "RECEIVE"
Model# and model name of
data sending and receive side.
Model number selection
- Use the (+) and (-) buttons to
make adjustments.
30 seconds wait is displayed
on the receive side screen.
Error
113
Fu
n
c
tio
n
2
(Select the setting item )
"MODE" by (JOG) button up or down operation, and select
the transfer side and receive
side by (+) or (-) button.
"TRANSFER" :Data transfer side
"RECEIVE"
:Data receive side
3
(Model memory selection)
Select the setting item "MDL"by (JOG) button up or down op-
eration of both T4PK, and select the transfer model number
and receive side model number by (+) or (-) button.
4
(Data transfer execution)
Select the setting item "EXEC" by (JOG) button up or down
operation of both T4PK.
First, press the receive side "RECEIVE" T4PK (+) and (-) but-
tons simultaneously. The mes-
sage "WAITING! 30S" appears
and count down begins.
Within 30 seconds, press the
transfer side "TRANSFER" T4PK
(+) and (-) buttons simultaneously. (If data transfer is not ex-
ecuted within 30 seconds, an error will be displayed at the
receive side "RECEIVE" T4PK.)
-"COMPLETE!" is displayed on the screen of the receive side "RECEIVE"
T4PK and data transfer is ended.
-If "RCV ERROR!" is displayed on the screen of the receive side "RE-
CEIVE" T4PK, data transfer was not performed normally. Check the con-
nection and repeat steps 1
4. Since the transfer side "TRANSFER" T4PK
only sends, "COMPLETE!" is displayed even when data transfer was not
performed normally.
Data Transfer "DTTRN"
Setup item selection
- Select by (JOG) button up or
down operation.
Mode change button
- Use the (+) and (-) buttons to
make adjustments.
Transfer execution button
- (+) and (-) buttons pressed
simultaneously for about 1 sec-
ond.