Futaba 4PK 2.4GHz - Manual (Page 34)

When radio waves are not being emitted when
turned on by display switch and when the
DSC function is used, "DISP" is displayed.
"RF"
When FASST-C2
"C2"
35
In
itial S
e
t-
Up
Before setting the Transmitter functions, check and set items 1 to 5 below.
Initial set-Up
Preparations (Transmitter)
(Display when power switch turned on)
When the power switch is turned on, the currently selected model number is displayed.
Check if this number is the model number you want to setup. To change the model num-
ber, use the Model Select function (See page 98).
(Start screen)
Turn on the transmitter power.
The model number is displayed.
1.RF Output Check
If signals are output normally, RF output monitor "RF" will be displayed on the screen.
If "RF" is not displayed, check if the transmitter crystal
and RF module are installed.
If the transmitter is abnormal or faulty, contact your Fu-
taba dealer.
2.Rx Type Check
The T4PK transmitter can use the Futaba 2.4GHZ R603FS/FF. However, there are two
types of Futaba 2.4GHz receiver for vehicles: "C1" type and "C2" type. The R603FS and
603FF are "C1" type. The R604FS supplied with the 4PK set
as standard is the "C2" type. Check that the setting matches
the receiver being used. For example, when using the R604FS,
the receiver type must be set to FASST-C2 and when using an
R603FS or R603FF, the receiver type must be set to FASS-C1.
If the setting is wrong, change it using the RX/SX type select
function (page 46).