Futaba 4PK 2.4GHz - Manual (Page 94)

95
Fu
n
c
tio
n
Timer Function "TIMER"
(Preparation)
Select the setting item "TYPE" by (JOG) button up or down
operation. Press the (+) or (-) button and select "LAP MEMO-
RY".
1
(Alarm time setting)
Select the setting item "ALRM"by (JOG) button up, down,
left, or right operation and set
the alarm time with the (+) and
(-) buttons.
(Pre alarm time setting)
Select the setting item "PRAL"
by (JOG) button up, down, left, or right operation, and set the
pre alarm time with the (+) and (-) buttons.
2
(Timer start/lap count operation)
Perform the start and lap count operations with the switch
("LAP START") assigned by function select switch function.
- Linking only start to the throt-
tle trigger
Select the setting item "RST"
by (JOG) button up, down, left,
or right operation and press the (+) and (-) buttons simultane-
ously for about 1 second. The set beeps and the timer display
changes from "RST" to blinking "RDY" and the set enters the
trigger operation ready state. (Status display "RUN")
3
(Timer stop/reset operation)
When the lap count switch ("LAP START") is pressed after
the time set with "ALRM" has elapsed, the timer stops and
the lap time, total time, and av-
erage time are memorized.
When the switch ("LAP RE-
SET") is pressed, the timer is
reset.
When a switch is not assigned, select the status display
("RUN", "STP", or "RDY") by (JOG) button up or down opera-
tion and press the (+) or (-) buttons simultaneously for about
1 second. The set beeps and the timer display changes to
"RST" and the timer resets.
- When the timer was stopped with the switch assigned the "LAP RESET"
function before the set "ALRM" time has elapsed, the total time and aver-
age time are not memorized.
Using the Lap timer timer
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons
simultaneously (approx. 1 sec)
to return to the initial screen.
Switches
LAP START :start / lap count
LAP RESET :stop / reset
Alarm time (ALRM)
OFF, 1 ~ 99 m
Initial value: 5 m
Prealarm time (PRAL)
OFF, 1 ~ 30 s
Initial value: OFF
Status display
RST :Reset state
RDY :Throttle trigger operation wait
RUN :Timer running
STP :
Timer stopped
Status display
RST :Reset state
RDY :Throttle trigger operation wait
RUN :Timer running
STP :
Timer stopped