Futaba 4PK 2.4GHz - Manual (Page 87)

88
Fu
n
c
tio
n
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* W h e n t h e d ire c t c all but to n
is set, the setup screen is also
called by the following method:
Function Select Dial "DIAL"
1
(Setting Dial selection)
Select the item you want to set by (JOG) button up, down,
left, or right operation.
2
(To select or change a function for Dial)
Select one of the functions for "DIAL" by pressing (+) or (-) button.
(To change the step amount)
Use the (+) or (-) button to set the step amount.
(When changing the direction of operation)
Use the (+) or (-) button to dial the direction.
3
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
Function select dial setup
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons
simultaneously (approx. 1 sec)
to return to the initial screen.
Initial value:
DL1
:"D/R", "2", "NOR"
DL2 :"ATL", "2", "NOR"
DL3 :"OFF"
DT1
:"ST-TR", "2", "NOR"
DT2 :"TH-TR", "2", "NOR"
DT3 :"OFF"
Function selection
Direction of operation setting
Step amount setting
Setup item selection
- Select by (JOG) button up,
down, left or right operation.
Function Select Dial "DIAL"
This function allows selection of the function performed by the digital dial (DL1/DL2/
DL3) and digital trimmers (DT1/DT2/DT3), step amount adjustment, and operating di-
rection reversal.
- The table below lists the functions that can be assigned to each dial and digital trimmer. The
assigned function is also displayed on the opening screen together with the current adjust-
ment value. They are displayed in DL1, DL2, DL3, DT1, DT2, and DT3 order, from top to
bottom.
- The step amount can be adjusted. The table below shows the relationship between set value
and step amount.
- The operation direction can be reversed. (NOR/REV)
s3ELECT button
* blinks at the current setup item.