Futaba 4PK 2.4GHz - Manual (Page 120)

121
Reference
Reference
Ratings
Transmitter T4PK
(Wheel system, 4 channels)
- Transmitting frequencies 2.4GHz band
- Futaba FASST-C2(R604FS), FASST-C1(R603FS/FF)
- Power requirement
(Ni-MH battery) NT5F1700B Ni-MH battery (6V)
(Dry cell battery) Penlight x 4 (6V)
- Current drain 250mA or less (Vibration and back lighting off)
- Transmitting anntenna 1/2
Receiver R604FS
(4 channels receiver)
- Receiving frequencies 2.4GHz band
- Power requirement 6.0V Ni-Cd battery (shared with servos)
- Current drain 95mA
- Size 39x26x14mm (1.54x1.02x0.55in)
- Weight 13.4g (0.47oz)
*Specifications and ratings are subject to change without prior notice.
ｎ Caution
ｊ When using the T4PK in the high speed (HIGH SPEED) mode, always use it under the following
conditions:
Servos : 6V Futaba digital servo (including BLS Series brushless servos)
Receiver’s Battery : 6V Ni-Cd battery
Transmitter mode : HIGH SPEED mode (See p.46 for setting method.)
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates.
In addition, it may cause servo trouble. Futaba will not be responsible for damage, etc. caused by combination with the
products of other companies.
In addition, the FSU1 Fail Safe Unit cannot be used because the system is different. Use the fail safe function of the
transmitter.
ｊ When using analog servos, always switch the T4PK servo response to the NORMAL mode.
Transmitter mode : NORMAL mode (See p.46 for setting method.)
Receiver’s Battery : 6V Ni-Cd battery
The set cannot operate in the HIGH SPEED mode. Operation in this mode will cause trouble of servo and other equipments.
Digital servos (including BLS Series brushless servos) can also be used in the NORMAL mode.