Interlogix NS3550-8T-2S User Manual - Manual (Page 239)

User’s Manual of NS3550-8T-2S
239
letter (see Abbr) has enabled port security.
 State Shows the current state of the port. It can take one of four values:

Disabled : No user modules are currently using the Port Security
service.

Ready : The Port Security service is in use by at least one user
module, and is awaiting frames from unknown MAC addresses to
arrive.

Limit Reached : The Port Security service is enabled by at least the
Limit Control user module, and that module has indicated that the limit
is reached and no more MAC addresses should be taken in.

Shutdown : The Port Security service is enabled by at least the Limit
Control user module, and that module has indicated that the limit is
exceeded. No MAC addresses can be learned on the port until it is
administratively re-opened on the Limit Control configuration
Web-page.
 MAC Count (Current,
Limit)
The two columns indicate the number of currently learned MAC addresses
(forwarding as well as blocked) and the maximum number of MAC addresses
that can be learned on the port, respectively.
If no user modules are enabled on the port, the Current column will show a dash
(-).
If the Limit Control user module is not enabled on the port, the Limit column will
show a dash (-).
Buttons
Auto-refresh
: Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
: Click to refresh the page immediately.