Interlogix NS3550-8T-2S User Manual - Manual (Page 321)

User’s Manual of NS3550-8T-2S
321
disable : Disable all power control
actiphy : Enable ActiPHY power control
dynamic : Enable Dynamic power control
Default Setting:
disable
Example:
Disable port power function for port1-4
NS3550-8T-2S:/>port power 1-4 enable
Port Excessive
Description:
Set or show the port excessive collision mode.
Syntax:
Port Excessive [<port_list>] [discard|restart]
Parameters:
<port_list> : Port list or 'all', default: All ports
discard : Discard frame after 16 collisions
restart : Restart backoff algorithm after 16 collisions
(default: Show mode)
Default Setting:
Discard
Example:
NS3550-8T-2S:/>port excessive 1 restart
Port Statistics
Description:
Show port statistics.
Syntax:
Port Statistics [<port_list>] [<command>] [up|down]
Parameters:
<port_list> : Port list or 'all', default: All ports
<command> : The command parameter takes the following values:
clear : Clear port statistics
packets : Show packet statistics
bytes : Show byte statistics
errors : Show error statistics
discards : Show discard statistics
filtered : Show filtered statistics
0..7 : Show priority statistics
(default: Show all port statistics)
up
: Show ports, which are up
down : Show ports, which are down
(default: Show all ports)
Port VeriPHY
Description:
Run cable diagnostics.
Syntax:
Port VeriPHY [<port_list>]
Parameters: