Interlogix NS3550-8T-2S User Manual - Manual (Page 465)

User’s Manual of NS3550-8T-2S
465
enable|disable : enable/disable
MEP Test Signal Configuration
Description:
MEP Test Signal configuration
'set|clear' is set or clear of DEI of transmitted LBM frame
'prio' is the priority (PCP) of transmitted TST frame
'mep' is the peer MEP-ID of target MEP - only used if 'mac_addr is 'all zero'
'no_seq|seq' is without and with transmitted sequence numbers
'rate' is the TST frame transmission bit rate in Mbps'
'size' is the size of the un-tagged TST frame - four bytes will be added for each tag
'allzero|allone|onezero' is pattern contained in the TST frame data TLV.
Syntax:
MEP tst config [<inst>] [set|clear] [<prio>] [<mep>] [no_seq|seq] [<rate>] [<size>] [allzero|allone|onezero] [enable|disable]
Parameters:
<inst> : Instance number
set|clear : OAM DEI set/clear
<prio> : OAM PDU priority
<mep> : This MEP id (0-0x1FFF)
no_seq|seq : TST sequence number transmission
<rate> : Transmission bit rate of TST frames - in Mbps
<size> : Size of TST data field in bytes (max 1518)
allzero|allone|onezero : Data pattern to be filled in TST PDU
enable|disable : enable/disable
MEP State
Description:
MEP state get.
Syntax:
MEP state [<inst>]
Parameters:
<inst> : Instance number
MEP Loss Measurement State
Description:
MEP Loss Measurement state get.
Syntax:
MEP lm state [<inst>]
Parameters:
<inst> : Instance number
MEP Loss Measurement State Clear
Description:
MEP Loss Measurement state clear
Syntax:
MEP lm clear <inst>
Parameters:
<inst> : Instance number
MEP Link Trace State
Description: